Comments on: Monitor HP Proliant with Nagios or Op5 Monitor http://www.it-slav.net/blogs/2010/03/02/monitor-hp-proliant-with-nagios-or-op5-monitor/ Another Blog from a Geek that has no life Fri, 03 Sep 2010 22:33:58 +0200 http://wordpress.org/?v=2.9.2 hourly 1 By: Gusten Hoffman http://www.it-slav.net/blogs/2010/03/02/monitor-hp-proliant-with-nagios-or-op5-monitor/comment-page-1/#comment-6549 Gusten Hoffman Tue, 11 May 2010 13:25:25 +0000 http://www.it-slav.net/blogs/?p=1644#comment-6549 Hello, I've found that HP has an supportpack for CentOS on their website. I have downloaded that and succesfully ínstalled it on my CentOS based HP PL320 G6 system. Just dowload and unpack, then install the rpm-packs one by one. There is an "ReleaseNotes.txt" that is "kinda" helpful :) I use an plugin called "check_compaq" that works like an charm with this setup. Regards, Gusten Hello,

I’ve found that HP has an supportpack for CentOS on their website. I have downloaded that and succesfully ínstalled it on my CentOS based HP PL320 G6 system. Just dowload and unpack, then install the rpm-packs one by one.
There is an “ReleaseNotes.txt” that is “kinda” helpful :)
I use an plugin called “check_compaq” that works like an charm with this setup.

Regards,
Gusten

]]> By: Gerhard Lausser http://www.it-slav.net/blogs/2010/03/02/monitor-hp-proliant-with-nagios-or-op5-monitor/comment-page-1/#comment-6437 Gerhard Lausser Fri, 05 Mar 2010 00:50:28 +0000 http://www.it-slav.net/blogs/?p=1644#comment-6437 Wow, thanks for writing about my plugin. Two things may be also interesting for you: - the lastest version can also be used to monitor HP Blade Centers (checks Blades, Power supplies). These Bladecenters seem to gain a lot of popularity. - adding "-v" to check_hpasm outputs a line for each component of the system (fans, memory modules, power supplies, disks,...). The above graphik would look the same, but by clicking on "Insight Manager" you would see all this extra information in the service detail window. Greetings from Munich, Gerhard Wow, thanks for writing about my plugin. Two things may be also interesting for you:
- the lastest version can also be used to monitor HP Blade Centers (checks Blades, Power supplies). These Bladecenters seem to gain a lot of popularity.
- adding “-v” to check_hpasm outputs a line for each component of the system (fans, memory modules, power supplies, disks,…). The above graphik would look the same, but by clicking on “Insight Manager” you would see all this extra information in the service detail window.

Greetings from Munich,
Gerhard

]]>